PrintrBot Play

From Bloominglabs
Revision as of 23:16, 19 November 2017 by Avh.on1 (Talk | contribs)

Jump to: navigation, search

A pre-assembled Printrbot Play (model 1505) was donated around 7 November 2016. It is one of several 3D Printers Bloominglabs has.

The complete, official documentation can be found on this Google Drive folder.



Printer has been in a nonfunctional state.

February 23, 2017 reloaded bootloader and firmware with avrdude and a USBtinyISP programmer.

Reference reprap.org/wiki/printrboard

BootloaderHID.hex play-0.6.hex

With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine.

Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.

Personal tools