PrintrBot Play: Difference between revisions
From Bloominglabs
Jump to navigationJump to search
No edit summary |
(Nearing functional state.) |
||
Line 14: | Line 14: | ||
[https://github.com/Printrbot/firmware-updater/blob/gh-pages/binaries/ play-0.6.hex] |
[https://github.com/Printrbot/firmware-updater/blob/gh-pages/binaries/ play-0.6.hex] |
||
With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine. |
|||
All seems to be working fine now except '''auto-leveling''' Z-axis which is a '''show stopper''' : ( |
|||
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150. |
|||
Revision as of 10:02, 3 March 2017
A pre-assembled Printrbot Play (model 1505) was donated around 7 November 2016.
Documentation can be found on this Google Drive folder.
Printer has been in a nonfunctional state.
February 23, 2017 reloaded bootloader and firmware with avrdude and a USBtinyISP programmer.
Reference reprap.org/wiki/printrboard
BootloaderHID.hex play-0.6.hex
With an ATX power supply, controller board, firmware, steppers, and sensors seem to be working fine.
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.