Restoration of Craftsman 4" joiner: Difference between revisions
From Bloominglabs
Jump to navigationJump to search
(Created page with "Jesse brought in a Craftsman 4" jointer on 03/16/2016. This tool has been in a barn for a couple decades and will need significant work to be truly operational. However the ...") |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
Jesse brought in a Craftsman 4" jointer on 03/16/2016. This tool has been in a barn for a couple decades and will need significant work to be truly operational. However the basic functionality is there - the motor runs and the blades cut. |
Jesse brought in a Craftsman 4" jointer on 03/16/2016. This tool has been in a barn for a couple decades and will need significant work to be truly operational. However the basic functionality is there - the motor runs and the blades cut. |
||
⚫ | |||
'''Before restoration''' |
|||
⚫ | |||
⚫ | |||
⚫ | |||
Line 5: | Line 12: | ||
The jointer needs a fair bit of work before it can be effectively used: |
The jointer needs a fair bit of work before it can be effectively used: |
||
* Remove rust from bed, with oil + steel wool, then sandpaper from course up to 1000 grit |
* Remove rust from bed, with oil + steel wool, then sandpaper from course up to 1000 grit |
||
* [optional] Buy non-silicone wax for bed |
|||
* Research the fence, figure out how it's supposed to provide rigidity, and fix it |
* Research the fence, figure out how it's supposed to provide rigidity, and fix it |
||
* Replace the belt |
* Replace the belt |
||
== Planned improvements == |
== Planned improvements == |
||
* |
* Build a replacement stand |
||
* Install a hinged motor mount for belt tensioning |
* Install a hinged motor mount for belt tensioning |
||
* Add a belt guard |
* Add a belt guard |
||
Line 17: | Line 24: | ||
== Restoration resources == |
== Restoration resources == |
||
[http://vintagemachinery.org/photoindex/detail.aspx?id=13633 Completed restoration @ Vintage Machinery] |
|||
Nothing yet... |
|||
⚫ | |||
⚫ | |||
⚫ | |||
⚫ |
Latest revision as of 08:05, 31 March 2016
Jesse brought in a Craftsman 4" jointer on 03/16/2016. This tool has been in a barn for a couple decades and will need significant work to be truly operational. However the basic functionality is there - the motor runs and the blades cut.
Photos
Before restoration
Usability
The jointer needs a fair bit of work before it can be effectively used:
- Remove rust from bed, with oil + steel wool, then sandpaper from course up to 1000 grit
- [optional] Buy non-silicone wax for bed
- Research the fence, figure out how it's supposed to provide rigidity, and fix it
- Replace the belt
Planned improvements
- Build a replacement stand
- Install a hinged motor mount for belt tensioning
- Add a belt guard
- Add a starter switch