PrintrBot Simple: Difference between revisions
From Bloominglabs
Jump to navigationJump to search
(Creating project page for the PrintrBot.) |
mNo edit summary |
||
Line 1: | Line 1: | ||
[http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)] |
[http://help.printrbot.com/c/Old_Simple PrintrBot Simple v1 (1310)] |
||
Useful things to know: |
|||
USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed. |
USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed. |
||
Revision as of 09:42, 21 October 2015
Useful things to know: USB needs to have 12volt power supplied to other power connector. I will try to find out what amperage is needed.
Serial is set up be 115200 baud.
Arduino terminal can be used to directly talk to the PrintrBot. Useful g-codes to use:
M115
Reports Firmware installed.
M114
Reports position.
M119
Reports endpoint status.
cura software GPL AFFERO V1